Diken Türksayar, Almira AdaDönmez, Mustafa BorgaOlcay, Emin OrkunDemirel, MünirDemir, Esra2022-05-312022-05-312022Turksayar AAD, Donmez MB, Olcay EO, Demirel M, Demir E. Effect of printing orientation on the fracture strength of additively manufactured 3-unit interim fixed dental prostheses after aging. J Dent. 2022 May 5:104155. doi: 10.1016/j.jdent.2022.104155. Epub ahead of print. PMID: 35526752.0300-5712http://doi.org/10.1016/j.jdent.2022.104155https://hdl.handle.net/20.500.12713/2761Objectives: To evaluate the effect of printing orientation on the fracture strength of 3-unit interim fixed dental prostheses fabricated by using additive manufacturing and to compare with those fabricated by subtractive manufacturing after thermomechanical aging. Materials and Methods: A 3-unit fixed dental prosthesis was designed by using a dental design software (exocad DentalCAD 2.2 Valetta) in standard tessellation language (STL) format. This STL file was exported into a nesting software (PreForm) and 3-unit interim fixed dental prostheses with 5 different orientations (0°, 30°, 45°, 90°, and 150°) were printed by using a 3-dimensional (3D) printing interim resin (Temporary CB) (n=10). The same STL file was also used to mill polymethymethacrylate (DuoCAD) 3-unit interim fixed dental prostheses as the control group (n=10). All specimens were cemented onto cobalt-chromium test models representing a maxillary first premolar and first molar tooth with a long-term temporary cement (DentoTemp), and subjected to thermomechanical aging (120000 cycles, 1.6 Hz, 50 N, 5-55°C). Then, all specimens were loaded until fracture by using a universal tester. The data were analyzed with nonparametric 1-way analysis of variance (Kruskal- Wallis) and Dunn’s tests (? = 0.05). 3 Results: Additively manufactured specimens printed with 90° showed the lowest fracture strength values (P?.048). However, the difference between specimens printed with 45° and 90° was nonsignificant (P>.05). Milled 3-unit interim fixed dental prostheses withstood significantly higher loads than 3-unit interim fixed dental prostheses printed with 45° and 150° (P?.012). In addition, specimens printed with 0° showed higher fracture strength than the specimens printed with 45° (P=.01). Specimens printed with 0° and 30° presented similar fracture strength values with milled (P?.057) and 150° printed (P>.05) specimens. Conclusion: Printing orientation had a significant effect on the fracture strength of 3-unit interim fixed dental prostheses. Among the additively manufactured samples, those printed with 0° showed similar fracture strength values with the subtractively manufactured samples. Clinical Significance Three-unit interim fixed dental prostheses fabricated with 0° and 30° using the 3D printing interim resin tested may be alternatives to milled PMMA in terms of fracture strengtheninfo:eu-repo/semantics/closedAccessFracture StrengthInterim RestorationPrinting OrientationHermomechanical AgingArticle35526752WOS:0008830333000022-s2.0-85134297810Q110.1016/j.jdent.2022.104155Q1