Dimensional stability of additively manufactured dentate maxillary diagnostic casts in biobased model resin
Küçük Resim Yok
Tarih
2024
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
MDPI
Erişim Hakkı
info:eu-repo/semantics/openAccess
Özet
This study aimed to evaluate the dimensional stability of maxillary diagnostic casts fabricated from a biobased model resin, which consists of 50% renewable raw materials for sustainable production, a model resin, and stone, over one month. A master maxillary stone cast was digitized with a laboratory scanner to generate a reference file. This master cast was also scanned with an intraoral scanner to additively manufacture casts with a biobased model resin (BAM) and a model resin (AM). Polyvinylsiloxane impressions of the master cast were also made and poured in type III stone (CV) (n = 8). The same laboratory scanner was used to digitize each model one day (T0), 1 week (T1), 2 weeks (T2), 3 weeks (T3), and 4 weeks (T4) after fabrication. Deviations from the reference file were calculated with an analysis software and analyzed with generalized linear model analysis (alpha = 0.05). The interaction between the material and the time point affected measured deviations (p < 0.001). Regardless of the time point, CV had the lowest and AM had the highest deviations (p < 0.001). BAM mostly had lower deviations at T0 and mostly had higher deviations at T4 (p <= 0.011). AM had the highest deviations at T4 and then at T3, whereas it had the lowest deviations at T0 (p <= 0.002). The measured deviations of CV increased after each time point (p < 0.001). BAM casts had deviations within the previously reported clinically acceptable thresholds over one month and had acceptable dimensional stability. Therefore, tested biobased resin may be a viable alternative for the sustainable manufacturing of maxillary diagnostic casts that are to be used clinically.
Açıklama
Anahtar Kelimeler
Additive Manufacturing, Biobased Model Resin, Dental Cast, Dimensional Stability, Sustainable Manufacturing
Kaynak
Materials
WoS Q Değeri
Q1
Scopus Q Değeri
Q2
Cilt
17
Sayı
9
Künye
Demirel, M., Diken Türksayar, A. A., Petersmann, S., Spintzyk, S., & Donmez, M. B. (2024). Dimensional Stability of Additively Manufactured Dentate Maxillary Diagnostic Casts in Biobased Model Resin. Materials, 17(9), 2128.
